Name: SILICON CP2102N-A02-GQFN28R
Brand: SILICON
Availability: InStock

产品实拍图

本型号暂无已核对的专属实拍图。为避免图文不符，本页不放同系列近似图；如需实物照片，请联系销售获取本批次实拍。

引脚定义与内部结构

引脚	符号	名称
5	Pin Definitions
4	OIPG
18	CTS
17	SUSPEND
16	NC
15	SUSPENDb
2	OIPG
3	OIPG
20	pin QFN
1	All dimensions shown are in millimeters (mm) unless otherwise noted.

数据来源：原厂规格书引脚图

关键参数速览

正向电流 IF: specification. If the 5 V

产品特点 Features

firmware complexity and reducing development time.
These highly-integrated USB-to-UART bridge controllers provide a simple solution for updating RS-232 designs to USB using a minimum of components and PCB space.
CP2102N devices enable quick USB connectivity with minimal development effort.
CP2102N is ideal for a wide range of applications, including the following:
Medical equipment
POS terminals
Data loggers
USB dongles
Gaming controllers
CP2102N
USB Battery
Remote Voltage
Charger
Wakeup Regulator
Detect
USB Connector

绝对最大额定值 Absolute Maximum Ratings（TA = 25°C）

超过下表数值可能造成器件永久损坏，设计时请留余量。

参数	符号	测试条件	最小	最大	单位
Storage Temperature	T		-65	150	°C
Voltage on VDD	V		GND-0.3	4.2	V
Voltage on VIO2	V IO		GND-0.3	4.2	V
Voltage on VREGIN	V		GND-0.3	5.8	V
Voltage on D+ or D-	V		GND-0.3	V +0.3	V
Voltage on UART pins, GPIO,	VBUS, V	V > 3.3 V	GND-0.3	5.8	V
USB pin		V IO < 3.3 V	GND-0.3	V IO +2.5	V
Total Current Sunk into Supply	Pin I		─	400	mA
Total Current Sourced out of	Ground I		400	─	mA
Current Sourced or Sunk by any	UART I		-100	100	mA
Operating Junction Temperature	T		-40	105	°C

数据来源：原厂规格书

电气特性 Electrical Characteristics（TA = 25°C）

参数	符号	测试条件	最小	典型	最大	单位
					CP2102N	Data Sheet
VDD Supply Monitor Threshold	V		1.95	2.05	2.15	V
Power-On Reset (POR) Threshold	V	Rising Voltage on VDD	—	1.2	—	V
		Falling Voltage on VDD	0.75	—	1.36	V
VDD Ramp Time	t	Time to V > 2.2 V	10	—	—	μs
Reset Delay from POR	t	Relative to V > V	3	10	31	ms
Reset Delay from non-POR	source t	Time between release of	reset —	50	—	μs
RSTb Low Time to Generate	Reset t		15	—	—	μs
		Table 3.4. Configuration	Memory
V DD Voltage During Programming	1 V PROG		3.0	—	3.6	V
Endurance (Write/Erase Cycles)	N		20k	100k	—	Cycles
		Table 3.5. Internal	Oscillator
Power Supply Sensitivity	PSS	T = 25 °C	—	0.02	—	%/V
Temperature Sensitivity	TS	V = 3.0 V	—	45	—	ppm/°C
					CP2102N	Data Sheet
		Table 3.6. 5V Voltage	Regulator
Input Voltage Range 1	V REGIN		3.0	—	5.25	V
Output Voltage on VDD 2	V REGOUT	Output Current = 1 to 100	mA 3.1	3.3	3.6	V
		Regulation range (VREGIN	≥ 4.1V)
		Output Current = 1 to 100	mA —	V –	—	V
		Dropout range (VREGIN <	4.1V)
Output Current 2	I REGOUT		—	—	100	mA
Dropout Voltage	V	Output Current = 100 mA	—	—	0.8	V
2.Output current is total	regulator output,	including any current required by	the device.
					CP2102N	Data Sheet
Output High Voltage (High	Drive) V	I = -7 mA, V ≥ 3.0 V	V - 0.7	—	—	V
	OH	OH IO	IO
		I = -3.3 mA, 2.2 V ≤ V OH IO	< 3.0 V V x 0.8 IO	—	—	V
		I = -1.8 mA, 1.71 V ≤ V	< 2.2 V
Output Low Voltage (High	Drive) V	I = 13.5 mA, V ≥ 3.0 V	—	—	0.6	V
		I = 7 mA, 2.2 V ≤ V < OL IO	3.0 V —	—	V x 0.2 IO	V
		I = 3.6 mA, 1.71 V ≤ V	< 2.2 V
Output High Voltage (Low	Drive) V	I = -4.75 mA, V ≥ 3.0	V V - 0.7	—	—	V
	OH	OH IO	IO
		I = -2.25 mA, 2.2 V ≤ V	< 3.0 V V x 0.8	—	—	V
		I = -1.2 mA, 1.71 V ≤ V	< 2.2 V
Output Low Voltage (Low Drive)	V	I = 6.5 mA, V ≥ 3.0 V	—	—	0.6	V
		I = 3.5 mA, 2.2 V ≤ V OL IO	< 3.0 V —	—	V x 0.2 IO	V
		I = 1.8 mA, 1.71 V ≤ V	< 2.2 V
Input High Voltage	V		V - 0.6	—	—	V
Input Low Voltage	V		—	—	0.6	V
Pin Capacitance	C		—	7	—	pF
Weak Pull-Up Current	I	V = 3.6	-30	-20	-10	μA
Input Leakage (Pullups off or	Ana- I	GND < V < V	-1.1	—	1.1	μA
Input Leakage Current with V	I	V < V < V +2.0 V	0	5	150	μA
RS485 Setup Time before Start	t		0	—	64.02	ms
RS485 Hold Time after Stop	Bit1 t RS485H		0	—	64.02	ms
TX Toggle Rate	f		—	20	—	Hz
RX Toggle Rate	f		—	20	—	Hz
					CP2102N	Data Sheet
Output High Voltage	V	V ≥ 3.0V	2.8	—	—	V
Output Low Voltage	V	V ≥ 3.0V	—	—	0.8	V
Output Crossover Point	V		1.3	—	2.0	V
Output Impedance	Z	Driving High	28	36	44	Ω
		Driving Low	28	36	44
Pull-up Resistance	R	Full Speed (D+ Pull-up)	1.425	1.5	1.575	kΩ
Output Rise Time	T	Full Speed	4	—	20	ns
Output Fall Time	T	Full Speed	4	—	20	ns
Differential Input	V	\| (D+) - (D-) \|	0.2	—	—	V
Differential Input Common	Mode V		0.8	—	2.5	V
Input Leakage Current	I	Pullups Disabled	—	<1.0	—	μA
		Table 3.9. Thermal	Conditions
Thermal Resistance (Junction	to θ	QFN20 Packages	─	60	─	°C/W
		QFN24 Packages	─	30	─	°C/W
		QFN28 Packages	─	26	─	°C/W
Thermal Resistance (Junction	to θ	QFN20 Packages	─	32.9	─	°C/W
		QFN24 Packages	─	24.2	─	°C/W
		QFN28 Packages	─	18.8	─	°C/W
Thermal Characterization	Parame- Ψ	QFN20 Packages	─	0.88	─	°C/W
		QFN24 Packages	─	0.3	─	°C/W
		QFN28 Packages	─	0.3	─	°C/W
						CP2102N Data Sheet

订货信息与供货形式

包装	and	包装2	(Optional)
Tape	and	Reel	(Optional)

应用领域 Applications

Medical equipmentPOS terminalsData loggersUSB donglesGaming controllersCP2102NUSB BatteryRemote VoltageChargerWakeup RegulatorDetectUSB Connector

资料下载

📄 CP2102N-A02-GQFN28R 规格书 PDF（同系列）

规格书为原厂公开资料，点击在新窗口打开下载。

获取报价 / 申请样品

常备现货、免费送样、支持小批量试产。报出用量与封装要求，当天给报价与交期。

💬 咨询 / 询价查看完整产品目录

CP2102N-A02-GQFN28R USB 桥接芯片