产品应用与封装尺寸


图纸取自原厂规格书,点击可放大查看原始尺寸标注。
引脚定义与内部结构
| 引脚 | 符号 | 名称 |
|---|---|---|
| 4 | RECOGNITION | |
| 5 | GND | |
| 6 | VE | |
| 7 | VO | |
| 8 | VCC |
数据来源:原厂规格书引脚图
关键参数速览
- 正向电压 VF
- 6.0
- 电源电压 VCC
- 500
- 工作温度 TA
- 1
产品特点 Features
- Compatible with LSTTL, TTL, and CMOS logic stage and has a detector threshold with hysteresis. The
- Wide V range (4.5 to 20 V) three state output eliminates the need for a pullup CC
- Three state output (no pullup resistor required)
- Guaranteed performance from 0°C to 85°C
- A superior internal shield on the HCPL-2219 guarantees
- Hysteresis common mode transient immunity of 2.5 kV/µs at a
- Selection Guide
- Small-Outline Widebody
- Minimum CMR 8-Pin DIP (300 Mil) SO-8 (400 Mil) Hermetic
- Input On- Single Dual Single Single Single and Dual dV/dt V Current Channel Channel Channel Channel Channel
- (V/µs) (V) (mA) Package Package Package Package Packages
- 1,000 50 1.6 HCPL-2200[1] HCPL-0201 HCNW2201
- HCPL-2201
- HCPL-2202
- 1.8 HCPL-2231
- 2,500 400 1.6 HCPL-2219[1]
绝对最大额定值 Absolute Maximum Ratings(TA = 25°C)
超过下表数值可能造成器件永久损坏,设计时请留余量。
| 参数 | 符号 | 最小 | 最大 | 单位 | 备注 |
|---|---|---|---|---|---|
| Storage Temperature | T | -55 | 125 | °C | |
| Operating Temperature | T | -40 | 85 | °C | 1 |
| Average Forward Input Current | I | 10 | mA | ||
| Peak Transient Input Current | I | 1.0 | A | ||
| Average Output Current | I | 25 | mA | ||
| Supply Voltage | V | 0 | 20 | V | |
| Three State Enable Voltage | V | -0.5 | 20 | V | |
| Output Voltage | V | -0.5 | 20 | V | |
| Total Package Power Dissipation | P | 210 | mW | 1 | |
| Lead Solder Temperature | 260°C for | 10 sec., 1.6 mm | below seating | plane |
数据来源:原厂规格书
安全与绝缘额定值(DIN EN/IEC 60747−5−5)
| 参数 | 符号 | 值 | 单位 | 条件 |
|---|---|---|---|---|
| Min. External Air | Gap L(IO1) | 7.1 | mm | Measured from input terminals to output terminals, |
| (External Clearance) | shortest distance through air. | |||
| Min. External | L(IO2) | 7.4 | mm | Measured from input terminals to output terminals, |
| Tracking Path | shortest distance path along body. | |||
| Minimum Internal | 0.08 | mm | Through insulation distance, conductor to conductor, | |
| Plastic Gap | usually the direct distance between the photoemitter | |||
| (Internal Clearance) | and photodetector inside the optocoupler cavity. | |||
| Tracking Resistance | CTI | 200 | V | DIN IEC 112/VDE 0303 Part 1 |
| Isolation Group | IIIa | Material Group (DIN VDE 0110, 1/89, Table 1) | ||
| Option 300 – surface | mount classification | is Class | A in accordance | with CECC 00802. |
电气特性 Electrical Characteristics(TA = 25°C)
| 参数 | 符号 | 最小 | 典型 | 最大 | 单位 | 测试条件 | 图号 | 备注 |
|---|---|---|---|---|---|---|---|---|
| A | CC | F(ON) | EH EL | F(OFF) | ||||
| All Typicals at T = | 25°C, V = 5 V, I | = 3 | mA unless | otherwise | specified. | See Note 7. | ||
| Logic Low | V | 0.5 | V I | = 6.4 mA (4 TTL Loads) | 1 | |||
| Logic High | V | 2.4 | * | V I | = -2.6 mA *V = V - 2.1 V | 2 | ||
| OH | OH | OH CC | ||||||
| Output Leakage | I | 100 | µA V | = 5.5 V I = 5 mA | ||||
| OHH | O | F | ||||||
| Current (V OUT > V | CC ) | 500 | µA V | = 20 V V CC = 4.5 V | ||||
| Logic High Enable | V | 2.0 | V | |||||
| Logic Low Enable | V | 0.8 | V | |||||
| Logic High Enable | I | 20 | µA V | = 2.7 V | ||||
| Current | 100 | µA V | = 5.5 V | |||||
| 0.004 | 250 | µA V | = 20 V | |||||
| Logic Low Enable | I | -0.32 | mA V | = 0.4 V | ||||
| Logic Low Supply | I | I = 0 mA | ||||||
| CCL | 4.5 | 6.0 | mA V | = 5.5 V F | ||||
| 5.25 | 7.5 | mA V | = 20 V V = Don’t | Care | ||||
| Logic High Supply | I | I = 5 mA | ||||||
| CCH | 2.7 | 4.5 | mA V | = 5.5 V F | ||||
| 3.1 | 6.0 | mA V | = 20 V | |||||
| CC | V = Don’t | Care | ||||||
| High Impedance | I | -20 | µA V | = 0.4 V V = 2 V, | ||||
| OZL | O | EN | ||||||
| State Output | Current | I = 5 mA | ||||||
| I | 20 | µA V | = 2.4 V V = 2 V, | |||||
| OZH | O | EN | ||||||
| 100 | µA V | = 5.5 V I = 5 mA | ||||||
| 500 | µA V | = 20 V | ||||||
| Logic Low Short | I | 2 | ||||||
| OSL | 25 | mA V O | = V = 5.5 V I = 0 mA CC F | |||||
| Current | 40 | mA V | = V = 20 V | |||||
| Logic High Short | I | I = 5 mA, | 2 | |||||
| OSH | -10 | mA V | = 5.5 V F | |||||
| Current | -25 | mA V CC | = 20 V | |||||
| Input Current | I | 0.12 | mA V | = 5 V | 3 | |||
| Input Forward | V | 1.5 | 1.7 | V T | = 25°C I = 5 mA | 4 | ||
| F | A | F | ||||||
| Input Diode | ∆V | -1.7 | mV/°C I = | 5 mA |
订货信息与供货形式
| 型号 | RoHS | non | RoHS2 | Surface | Gull | 包装 | UL | 5000 | Vrms/ | IEC/EN/DIN |
|---|---|---|---|---|---|---|---|---|---|---|
| under | CSA | Component | Acceptance | Notice #5, File | CA 88324. | |||||
| Part | RoHS | non | RoHS | Surface | Gull | Tape | UL | 5000 | Vrms/ | IEC/EN/DIN |
| Number | Compliant | Compliant Package | Mount | Wing | & Reel | 1 | Minute | rating | EN 60747-5-2 Quantity | |
| HCPL-2200 | -300E | -300 | X | X | 50 per tube | |||||
| HCPL-2219 | -500E | -500 | X | X | X | 1000 per reel | ||||
| the | option column | to | form an order | entry. | ||||||
| packaging | with | IEC/EN/DIN | EN | 60747-5-2 Safety | Approval | and | RoHS | compliant. |
