产品实拍图
本页为博科信现货实拍（器件丝印 见规格书）。图片已加防盗水印，需要最新批次照片或未加水印原图请联系销售；点击图片可放大。
产品应用与封装尺寸
图纸取自原厂规格书，点击可放大查看原始尺寸标注。
引脚定义与内部结构
| 引脚 | 符号 | 名称 |
|---|---|---|
| 5 | GND | |
| 6 | V | |
| 7 | V | |
| 8 | CASE |
数据来源：原厂规格书引脚图
关键参数速览
- 正向电压 VF
- 1.70
- 电流传输比 CTR
- 50
- 电源电压 VCC
- −0.5 to 30
- 工作温度 TA
- −40 to +100
产品特点 Features
- High Speed – 1 MBit/s 6N135 = Device Number
- V = DIN EN/IEC60747−5−5 Option (only
- Dual−Channel: HCPL2530M, HCPL2531M appears on component ordered with this
- Single−Channel: 6N135M, 6N136M, HCPL4503M
- HCPL2531M
- SCHEMATICS
- N/C 1 8 V + 1
- + 2 7 V 2
- 3 6 V 3
- N/C 4 5 GND + 4
- 6N135M, 6N136M,
- HCPL4503M
- Pin 7 is not connected in the HCPL4503M
- Figure 1. Schematics
- HCPL2530M,
- 5 GND
绝对最大额定值 Absolute Maximum Ratings（TA = 25°C）
超过下表数值可能造成器件永久损坏，设计时请留余量。
| 符号 | 参数 | 测试条件 | 值 | 单位 |
|---|---|---|---|---|
| T Storage | Temperature | −40 to +125 | °C | |
| T Operating | Temperature | −40 to +100 | °C | |
| T Junction | Temperature | −40 to +125 | °C | |
| T Lead Solder | Temperature | 260 for 10 s | °C | |
| I (avg) DC/Average | Forward Input Current Each Channel | (Note 2) | 25 | mA |
| I (pk) Peak Forward | Input Current Each Channel (Note 3) | 50% Duty Cycle, 1 ms P.W. | 50 | mA |
| I (trans) Peak Transient | Input Current Each Channel | ≤1 kΩs P.W., 300 pps | 1.0 | A |
| P Input Power | Dissipation Each Channel (Note 4) | 45 | mW | |
| I (avg) Average | Output Current Each Channel | 8 | mA | |
| I (pk) Peak Output | Current Each Channel | 16 | mA | |
| V Supply | Voltage | −0.5 to 30 | V | |
| V Output | Voltage | −0.5 to 20 | V | |
| I Base Current | 6N135M and 6N136M | 5 | mA | |
| P Output | Power Dissipation Each Channel (Note 5) | 100 | mW |
数据来源：原厂规格书
安全与绝缘额定值（DIN EN/IEC 60747−5−5）
| 符号 | 参数 |
|---|---|
| only within the safety limit data. | Compliance with the safety ratings shall be ensured by |
| Installation Classifications per DIN | VDE 0110/1.89 Table 1, For Rated Mains Voltage |
| Pollution Degree (DIN VDE 0110/1.89) | |
| V Input−to−Output | Test Voltage, Method A, V x 1.6 = V , |
| Type and Sample | Test with t = 10 s, Partial Discharge < 5 pC |
| Input−to−Output | Test Voltage, Method B, V x 1.875 = V , |
| 100% Production | Test with t = 1 s, Partial Discharge < 5 pC <150 V I–IV <300 V I–IV <450 V I–III <600 V I–III 1,335 V 1,669 V |
| V Highest Allowable | Over−Voltage |
| External Clearance | (for Option TV, 0.4” Lead Spacing) 6,000 V ≥8.0 mm ≥7.4 mm ≥10.16 mm ≥0.5 mm |
| only within the safety limit data. | Compliance with the safety ratings shall be ensured by |
| Installation Classifications per DIN | VDE 0110/1.89 Table 1, For Rated Mains Voltage |
| Pollution Degree (DIN VDE 0110/1.89) | |
| V Input−to−Output | Test Voltage, Method A, V x 1.6 = V , |
| Type and Sample | Test with t = 10 s, Partial Discharge < 5 pC |
| Input−to−Output | Test Voltage, Method B, V x 1.875 = V , |
| 100% Production | Test with t = 1 s, Partial Discharge < 5 pC |
| V Maximum Working | Insulation Voltage |
| V Highest Allowable | Over−Voltage |
| External Clearance | (for Option TV, 0.4” Lead Spacing) |
| DTI Distance Through | Insulation (Insulation Thickness) |
| T Case Temperature | (Note 1) |
| I Input Current (Note | 1) |
| P Output Power (Duty | Factor ≤ 2.7%) (Note 1) |
| R Insulation Resistance | at T , V = 500 V (Note 1) <150 V I–IV <300 V I–IV <450 V I–III <600 V I–III 1,335 V 1,669 V 890 V 6,000 V ≥8.0 mm ≥7.4 mm ≥10.16 mm ≥0.5 mm 150 °C 200 mA 300 mW >109 µ |
电气特性 Electrical Characteristics（TA = 25°C）
| 符号 | 参数 | 器件 | 测试条件 | 最小 | 典型 | 最大 | 单位 |
|---|---|---|---|---|---|---|---|
| V | Input Forward Voltage | All I | = 16 mA, T = 25°C | − | 1.45 | 1.70 | V |
| All I | = 16 mA | − | − | 1.80 | |||
| V /T | Temperature Coefficient | All I | = 16 mA | − | −1.7 | − | mV/°C |
| Logic High Output | All I | = 0 mA, V = V = 5.5 V, T = | 25°C − | 0.0007 | 0.5 | kΩA | |
| 6N135M, I | = 0 mA, V = V = 15 V, T = | 25°C − | 0.0019 | 1 | |||
| All I | = 0 mA, V = V = 15 V | − | − | 50 | |||
| Logic Low Supply | 6N135M, I | = 16 mA, V = Open, V = 15 | V − | 163 | 200 | kΩA | |
| HCPL2530M, I | = I = 16 mA, V = Open, | − | − | 400 | |||
| I | Logic High Supply | 6N135M, I | = 0 mA, V = Open, V = 15 V | − | 0.0004 | 2 | kΩA |
| CCH | F | O CC | |||||
| HCPL2530M, I | = 0 mA, V = Open, V = 15 V | − | − | 4 | |||
| TRANSFER | CHARACTERISTICS | (T = 0°C to 70°C unless | otherwise specified.) | ||||
| CTR | Current Transfer Ratio | 6N135M, I | = 16 mA, V = 0.4 V, V = 4.5 | V, 7 | 38 | 50 | % |
| 6N136M, | 19 | 38 | 50 | % | |||
| 6N135M I | = 16 mA, V = 4.5 V V = | 0.4 V 5 | − | − | % | ||
| HCPL2530M | V = | 0.5 V | |||||
| 6N136M, | V = | 0.4 V 15 | − | − | % | ||
| HCPL2531M | V = | 0.5 V | |||||
| V | Logic LOW Output | 6N135M I | = 16 mA, I = 1.1 mA, V = 4.5 | V, − | 0.12 | 0.4 | V |
| OL | F HCPL2530M | O CC | 0.5 | ||||
| 6N136M, I HCPL2531M | = 16 mA, I = 3 mA, V = 4.5 V, | − | 0.20 | 0.4 0.5 | |||
| 6N135M, I | = 16 mA, I = 0.8 mA, V = 4.5 | V − | 0.11 | 0.5 | |||
| HCPL4503M, I | = 16 mA, I = 2.4 mA, V = 4.5 | V − | 0.18 | 0.5 | |||
| Single−Channel: | 6N135M, 6N136M, | HCPL4503M | Dual−Channel: | HCPL2530M, | |||
| Single−Channel: | 6N135M, 6N136M, | HCPL4503M | Dual−Channel: | HCPL2530M, |
特性曲线（Typical Performance Curves）
相关 / 可替代型号
以上型号来自规格书与型号命名比对，参数需以各自规格书为准；下单前请与销售确认封装与脚位。